Searching for Press - watchmaker products

New pressure spring for setting lever for Omega caliber 480 part 1132

$24.00 Ex Tax: $24.00

New set of pressure spring for setting lever for Omega movement caliber 480. Reference number: 1132..

Rare Favorite 11001 press for fitting of unbreakable crystals with or without tension ring

$600.00 Ex Tax: $600.00

Pre-owned rare Favorite 11001 watch tool set, press for fitting of unbreakable crystals with or without tension ring. Full set with die taps..

Boley ETACHRON fork to press out the stud tool

$45.00 Ex Tax: $45.00

Boley ETACHRON special tool to remove the stud from the stud holder. Insert the tool into the opening between the stud support and the regulator, then carefully push the stud out o..

Bergeon 16918-TETC ETACHRON fork to press out the stud

$44.95 Ex Tax: $44.95

Bergeon 16918-TETC ETACHRON fork to press out the stud, special tool to remove the stud from the stud holder. Insert the tool into the opening between the stud support and the regu..

Omega 471 pressure spring for setting lever part 1132

$19.00 Ex Tax: $19.00

Pre-owned pressure spring for setting lever part for Omega watch with automatic movement of Omega caliber 471. Part number: 1132 Also used in caliber 470..

Bergeon 7499-A case press dies 13 piece set

$289.00 Ex Tax: $289.00

Bergeon 7499-A set of 13 black synthetic dies have straight sides and are reversible. They have a 5mm mounting hole and fit the Bergeon 5500 case press. Synthetic dies for fit..

Horotec MSA 13.010 universal correcting press facilitates the work of milling, drilling, tapping, deburring and etc.

$410.00 Ex Tax: $410.00

Horotec MSA 13.010 multifunctional press for drilling, milling, tapping, deburring, reaming. Large selection of collets type P 4.5 are available, fitting for the brooch with intern..

Horotec MSA05.021 watch hand fitting tool press for watches with 8 inserts

$149.99 Ex Tax: $149.99

Horotec MSA05.021 hand-setting tool with guide fitting for broaches, for easy fitting of hands to wrist and pocket watches.Contents:- 1 presser- 1 broach- 8 different inserts (0.5..

Watch seconds hand remover tool, hand setting and fitting press holder

$295.00 Ex Tax: $295.00

This tool was designed to make watch hand fitting as simple as possible Although this is just a stand, it is a generic model. The size of the hole is 8.0mm. It can support Bergeon..

Longines 507 pressure spring part 479

$12.00 Ex Tax: $12.00

Pre-owned pressure spring part for Longines watch with automatic movement of Longines caliber 507. Part number: 479 Also used in calibers: 501, 503, 505...

Longines 6942 pressure spring for setting-lever part 479

$22.00 Ex Tax: $22.00

Pre-owned pressure spring for setting-lever part for Longines watch with manual-winding movement of Longines caliber 6942. Part number: 479..

Omega 1001 pressure spring for setting lever part 1132

$14.00 Ex Tax: $14.00

Pre-owned pressure spring for setting lever part for Omega watch with automatic movement of Omega caliber 1001. Part number: 1132..

Rolex Sky Dweller tool special pressure stakes set of 5

$420.00 Ex Tax: $420.00

Rolex Sky Dweller special pressure stakes set of 5 top-quality press grip dies on a wooden base. With this set you can remove and replace the glass of the Rolex Sky Dweller, witho..

Horotec press 07.363 deluxe watch case opener with dies suitable with Rolex

$1,400.00 Ex Tax: $1,400.00

Horotec press 07.363 deluxe watch case opener with dies suitable with Rolex. A universal key of Swiss manufacture for opening / closing all watch cases with threaded base.The d..

Longines 6922 pressure spring for setting-lever part 479

$21.00 Ex Tax: $21.00

Pre-owned pressure spring for setting-lever part for Longines watch with manual-winding movement of Longines caliber 6922. Part number: 479..

Longines 6952 pressure spring for setting-lever part 479

$19.00 Ex Tax: $19.00

Pre-owned pressure spring for setting-lever part for Longines watch with manual-winding movement of Longines caliber 6952. Part number: 479..

Longines 431 pressure spring part 479

$17.00 Ex Tax: $17.00

Pre-owned pressure spring part for Longines watch with automatic movement of Longines caliber 431. Part number: 479..

Beco Profi Press spindle press with snap-in system with 8 pressure pieces

$187.00 Ex Tax: $187.00

Beco Professional Press spindle press with snap-in system Incl. 8 Pressure pieces without thread Version 2x plan 40 (hole Ø 5 mm and 8 mm) Each 1x 20/23 (hole Ø 8 mm); 26/29 (..

Bergeon set of 5 POM hollow stakes N°6527-5CP-XL for Bergeon N° 6173 and N° 5500

$145.00 Ex Tax: $145.00

Bergeon 6527-5CP-XL assortment of pressure stakes for Bergeon presses N° 6173 and N° 5500. For inserting domed mineral crystals and for closing waterproof cases. Thread M6 Cont..

Horotec MSA07.131 case closer Big-Press XL 12 threaded dies for watches

$315.00 Ex Tax: $315.00

Horotec MSA07.131 case closer Big-Press XL 12 threaded dies for watches. The large, robust case closer is designed for closing watch cases with push-fit bases and for fitting plast..

Boley tool for assembling movements for pressing or lifting bridges and wheels 115 mm

$25.00 Ex Tax: $25.00

Practical special tool from Boley for assembling movements with reinforced polyamide fibers, as well as very high tensile properties. One end pointed and one end flat. Ideal for pr..

Horotec MSA 07.305 handle for press for opening and closing case back watch

$80.00 Ex Tax: $80.00

Horotec MSA 07.305 handle for press for opening and closing case back watch. Dies not included. This is only handle...

Bergeon 5700-Z device press for opening and close waterproof watch cases

$840.00 Ex Tax: $840.00

Bergeon 5700-Z device press for opening and close waterproof watch cases up to a diameter of 60mm. This Swiss-made press is a universal key for opening diver's watches and water-re..

Bergeon 8250 watch case closer and crystal press fitting

$519.00 Ex Tax: $519.00

Bergeon 8250 is great for closing snap on watch backs as well as fitting crystals. The anodized aluminum frame is sturdy and features a non slip base and two holes for bench mounti..

Blue rubber diver watch strap with decompression table and stainless steel buckle 22 mm, 24 mm

$9.95 Ex Tax: $9.95

New blue rubber diver watch strap with decompression table and stainless steel buckle. Stop: 22 mm Width: 24 mm..

Blue rubber diver watch strap with decompression table and stainless steel buckle 20 mm, 22 mm

$9.95 Ex Tax: $9.95

New blue rubber diver watch strap with decompression table and stainless steel buckle. Stop: 20 mm Width: 22 mm..

Vintage Fortis Marinemaster automatic super compressor diver watch 1970s

$1,450.00 Ex Tax: $1,450.00

Up for sale a vintage Fortis Marinemaster automatic super compressor diver men's watch from 1970. In fully authentic condition, last service 09.08.2021, original glass, original cr..

Rubber diver watch strap with decompression table and stainless steel buckle 20 mm, 22 mm

$9.95 Ex Tax: $9.95

Rubber diver watch strap with decompression table and stainless steel buckle 20 mm, 22 mm..

Rubber diver watch strap with decompression table and stainless steel buckle 18 mm, 20 mm

$9.95 Ex Tax: $9.95

Rubber diver watch strap with decompression table and stainless steel buckle 18 mm, 20 mm..

Rubber diver watch strap with decompression table and stainless steel buckle 22 mm, 24 mm

$9.95 Ex Tax: $9.95

Rubber diver watch strap with decompression table and stainless steel buckle 22 mm, 24 mm..

Rubber diver watch strap with decompression table and stainless steel buckle 24 mm, 26 mm

$9.95 Ex Tax: $9.95

Rubber diver watch strap with decompression table and stainless steel buckle 24 mm, 26 mm..

Bergeon 8745-BSC watch press bracelet shortening removing tool

$245.00 Ex Tax: $245.00

Bergeon 8745-BSC Press Bracelet Shortening Removing Tool Watch Watches Press for multi-uses to drive in and out pinsMade of composite material.The support No 6744-P allows to main..

Omega 562 pressure spring for setting lever part 1132

$19.99 Ex Tax: $19.99

Pre-owned pressure spring for setting lever part for Omega watch with automatic movement caliber 562. Part number: 1132 Also used in calibers: 563, 564 and 565..

Omega 491 pressure spring for setting lever part 1132

$16.50 Ex Tax: $16.50

Pre-owned pressure spring for setting lever part for Omega watch with automatic movement caliber 491. Part number: 1132 Also used in calibers: 490..

Omega 1020, 1021, 1022 pressure spring for settling lever part 1132

$23.00 Ex Tax: $23.00

Pre-owned pressure spring for settling lever part for Omega watch with automatic movement of Omega caliber 1021. Part number: 1132 Also used in calibers: 1020, 1022..

Zenith 126 pressure spring for setting lever part

$16.00 Ex Tax: $16.00

Pre-owned pressure spring for setting lever part for Zenith watch with manual-winding movement of Zenith caliber 126. Part number: N/A..

Zenith 12-4-6, 12-4 pressure spring for setting lever part

$13.00 Ex Tax: $13.00

Pre-owned pressure spring for setting lever part for Zenith watch with manual-winding movement of Zenith caliber 12-4-6. Part number: N/A Also used in calibers: 12-4..

Omega 611 pressure spring for setting lever part 1132

$14.00 Ex Tax: $14.00

Pre-owned pressure spring for setting lever part for Omega watch with manual-winding movement caliber 611. Part number: 1132 Also used in calibers 610...

Omega 552 pressure spring for setting lever part 1132

$16.00 Ex Tax: $16.00

Pre-owned pressure spring for setting lever part for Omega watch with automatic movement of Omega caliber 552. Part number: 1132 Also used in caliber: 550, 551..

Universal Geneve 56 pressure spring for setting lever part

$16.00 Ex Tax: $16.00

Pre-owned pressure spring for setting lever part for Universal Geneve watch with manual-winding movement of Universal Geneve caliber 56. Part number: N/A..

Omega 503 pressure spring for setting lever part 1132

$16.00 Ex Tax: $16.00

Pre-owned pressure spring for setting lever part for Omega watch with automatic movement of Omega caliber 503. Part number: 1132..

Omega caliber 601 pressure spring for setting lever part 1132

$19.00 Ex Tax: $19.00

Pre-owned pressure spring for setting lever part for Omega watch with manual-winding movement of Omega caliber 601. Part number: 1132..

Omega caliber 1022 pressure spring for settling lever part 1132

$19.00 Ex Tax: $19.00

Pre-owned pressure spring for settling lever part for Omega watch with automatic movement of Omega caliber 1022. Part number: 1132..

Omega caliber 510 pressure spring for setting lever part 1132

$16.00 Ex Tax: $16.00

Pre-owned pressure spring for setting lever part for Omega watch with manual-winding movement of Omega caliber 510. Part number: 1132..

Omega caliber 750 pressure spring for setting lever part 1132

$13.00 Ex Tax: $13.00

Pre-owned pressure spring for setting lever part for Omega watch with automatic movement of Omega caliber 750. Part number: 1132 Fit with caliber: 550..